Laney IRT30-112 Manuel d'utilisateur

Set impedance switchto 4 Ohms when using the internal speaker with an8 Ohm extension cabinetSet impedance switchto 8 Ohms when using the internal spe

11This product conforms to the requirements of the following European Regulations, Directives & Rules:CE Mark (93/68/EEC), Low Voltage 2006/95/EC,

12TUBE AMP TIPSTube amplifiers generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due

~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz~100V>~120V T1.6A L~220V>~240V T630mA LT315mA L100W30WPre-Boost Input ControlSwitchable Channels, with

14WARNING: When using electrical products, basic cautions should always be followed, including the following:1. Read these instructions. 2. Keep these

15

Forged deep within the Black Country - the metal beating industrial heartland of the UK - where the sound of metal guitar was born, comes the IRONHEAR

FRONT PANEL CONTROLS1. INPUT: 1/4" mono jack socket. Connect your guitar here. Use only a good quality instrument cable.2. PRE-BOOST SWITCH: Sw

Once set, try using your guitar's volume controls to interactively adjust tone and distortion levels.9. CHANNEL SWITCH: Switches between the Lead

1. MAINS INLET SOCKET: Connect to your power source. Make sure the voltage indicated on the rear panel is correct for your country!2. MAINS FUSE: T

4. DI: Use this socket to connect your amplifier to a PA system or recording interface. It features a SOURCE switch to select either the fully process

9JazzBluesCleanFusion